3/20/2014 I picked up the wood flooring today. As you can see it completely filled the trailer. I bought a pneumatic staple gun. So I have to run a hose from the garage to the bedroom.
3/24/2014 Started putting down the floor on Saturday. Made a little jig for the router to make an AC floor vent out of the flooring material.
Getting there!
I bought a staple/nail pneumatic gun, what a life saver. There is nothing like having the right tool for the job. I've got an air hose running out the window to the garage.
3/26/2014 Well the floor is all done!! Now to do the floor boards and the trim. I need to get a mirror and build it into the closet door.
This is all the flooring I have left. Wow, that was close.
4/4/2014 Got the lights in.
Here is the light switch when you enter the bedroom. There are eight programmable buttons. The switches in the fans and sconces are wireless. This made the wiring a lot easier, didn't have to run wires to switches. There is a module in the cabinet in the living room that is connected to the Internet. The buttons are programmable from my laptop. So for instance, the G button turns the sconces on at 50% and the two fans on low speed. I can program how long it takes for the lights to ramp up to 50%. Anything I do this way in the house can also be controlled from our phones, from anyplace. Just wait until someone visits and we're out, we'll drive them crazy! I can change the buttons so they actually say when they do. You can see that the G button is lit too, so you know what is on. The B button only turns on the sconces at 50% and the C turns them on full.
Oh yes, got the fans in too.
Put a mirror in the pocket door to the closet.
Then picked up the new dresser today. I also got a new flue for the fireplace. The new one goes out the back, turns 45 degrees then right through the wall. I have to redo the fireplace frame a little to push the fireplace a little closer into the corner.
Then I need to build this. Lynn is coming down this Friday so I'm going to start this after her visit.
